Roll out your EcoTec FloorFoam to the appropriate length before cutting with scissors or a sharp blade. Cut where necessary for any radiator pipes.

Staple all the way around the FloorFoam that you have just put down with a Heavy Duty Staple Gun Kit. Trim around the edges for a neat finish. If the floor is concrete, this can be fixed down with a non-solvent adhesive or double sided tape.

Proceed with your second layer of Floor Foam, ensure it is butt jointed next to the first layer, it is important not to overlap the material. Repeat this step as required.

Once you've installed your FloorFoam and sealed to the flooring, then proceed with taping the perimeter and butt joints with ThermaSeal Joining Tape. This will prevent moisture and draughts from rising through the floor.

If you are laying a carpet, you can then proceed to fix into place the grippers on top of the FloorFoam (this will not affect its performance). Once done, you can now proceed to lay your flooring underlay and cut directly into place on top of the FloorFoam.

If installing a Vinyl floor, we recommend to install a think plywood of 3-4mm thick over the FloorFoam, this will give the Vinyl a completely solid ground to sit on as per the manufacturers recommendations. Finally, you can now put down your carpet or laminate flooring and enjoy your warm, draught free living space!

Start by rolling out FloorFoam Insulation either vertically or horizontally on the concrete floor. EcoTec FloorFoam can then easily be cut by using Multifoil Scissors or a Cutting Knife - Both available in our Multifoil Fitting Kit.

FloorFoam is fixed onto concrete floors by using Thermaseal Double Sided Tape, or Non-Solvent Glue. Ensure FloorFoam Insulation is fully taped and sealed on butt joints on the floor. Also tape FloorFoam around the perimeter. (Thermaseal Foil Tape is provided free of charge in the Insulation Kit). Taping and sealing ensures no draught or moisture can rise up through the floor.

Once your concrete floor has been covered with FloorFoam, next you can install your desired flooring. Wood & laminate flooring can be installed directly on top of FloorFoam. We recommend to use a carpet and laminate underlay prior to a carpet or laminate being installed. If a vinyl or lino is being used, we would advise the use of a plywood over the top of the FloorFoam.

Firstly, roll out EcoTec FloorFoam either horizontally or vertically on the timber floor. FloorFoam can then be cut to desired length. We recommend FloorFoam to be cut with a cutting knife or Multifoil Scissors (Available in Multifoil Fitting Kit)

Staple EcoTec FloorFoam on your timber floor at around 300mm intervals. Ensure FloorFoam Insulation is butt jointed together on both horizontal and vertical sections.

Fully tape and seal around the perimeter and butt joints using Thermaseal Foil Joining Tape (Provided free of charge in kit) Taping and sealing ensures no draught or moisture can rise up through the floor.

Once the timber floor is fully covered with FloorFoam Insulation, you can then proceed to install your desired flooring. If carpet is installed, the use of an underlay is advised prior to the carpet. Laminate or wood floors can be installed directly on top of FloorFoam. If a vinyl or lino is being used, we would advise the use of a plywood over the top of the FloorFoam.